E30 series BMW 3

since 1983-1994 of release

Repair and car operation

E30 BMW
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engine
   + 3.1.2. Specifications
   - 3.2. Dismantle and major maintenance of the engine
      3.2.2. Specifications
      3.2.3. Major maintenance – the general instructions
      3.2.4. Compression check in engine cylinders
      3.2.5. Major maintenance – general comments
      3.2.6. Engine diagnostics by means of the vacuum gage
      3.2.7. Major maintenance – alternatives
      3.2.8. Dismantle of the power unit
      3.2.9. Removal and engine installation
      3.2.10. Order of dismantling of the engine
      3.2.11. Dismantling of a head of the block of cylinders
      3.2.12. Cleaning and check of a head of cylinders and details of the klapanny mechanism
      3.2.13. Repair of valves
      3.2.14. Assembly of a head of the block of cylinders
      3.2.15. Removal of pistons and rods
      3.2.16. Crankshaft dismantle
      3.2.17. Intermediate shaft (only M20 engine)
      3.2.18. Cleaning of the block of cylinders
      3.2.19. Check of a condition of the block of cylinders
      3.2.20. Honningovaniye of cylinders
      3.2.21. Check of a condition of pistons and rods
      3.2.22. Check of a condition of the crankshaft
      3.2.23. Check of radical and shatunny bearings
      3.2.24. Engine assembly order
      3.2.25. Installation of piston rings
      3.2.26. Installation of an intermediate shaft
      3.2.27. Installation of the crankshaft and check of gaps in radical bearings
      3.2.28. Installation of a back epiploon
      3.2.29. Installation of rods and pistons, check of gaps in shatunny bearings
      3.2.30. Engine start-up after repair and a running in
   + 3.3. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice

3.2.20. Honningovaniye of cylinders

GENERAL INFORMATION

The adaptation for a honningovaniye of cylinders

PERFORMANCE ORDER

1. For a honningovaniye it is recommended to use "ершик". Previously put covers of radical bearings and tighten bolts with the set moment.
2. Clamp the adaptation in an electrodrill.
	3. Well oil a cylinder surface, include an electrodrill both periodically move up and down in the cylinder. Thus on a surface of walls of the cylinder the structure of the thin lines which are crossing at an angle about 60 ° should be formed. Ershik to get only after a full stop of a drill.
4. After a honningovaniye carefully clear and wash out the block of cylinders. At sufficient degree of purity on the pure white rags moistened with oil, should not remain particles of gray color if to carry out it on a cylinder wall.