E30 series BMW 3

since 1983-1994 of release

Repair and car operation

E30 BMW
+ 1. Maintenance instruction
- 2. Maintenance
   2.2. Recommended lubricants and liquids
   2.3. Periodicity of service
   2.4. Features of routine maintenance of the car
   2.5. General information on additional maintenance
   2.6. Check of level of liquids
   2.7. Check of a condition of tires and pressure in tires
   2.8. Oil replacement in the engine and the oil filter
   2.9. Check and restoration of level of liquid in a wheel
   2.10. Check of level of liquid in automatic transmission
   2.11. Shift of wheels
   2.12. Check and replacement of hoses in a motor compartment
   2.13. Check, adjustment and replacement of belts of a drive of hinged units
   2.14. Check and adjustment of turns and quality of a mix (FROM) idling
   2.15. Check of a condition and battery charging
   2.16. Check and replacement of candles
   2.17. Check of high-voltage wires, begunka and distributor covers
   2.18. Check of level of oil in a manual transmission
   2.19. Check of level of oil in the main transfer
   2.20. Check and adjustment of gaps in valves (except the M40 engine)
   2.21. Draft of a butterfly valve
   2.22. Replacement of the air filter
   2.23. Check of fuel system
   2.24. Check of system of cooling
   2.25. Check of an exhaust system
   2.26. Check of shock-absorbers, suspension bracket and steering
   2.27. Check of covers of semi-axes
   2.28. Check of brakes
   2.29. Check of brushes of screen wipers
   2.30. Liquid replacement in automatic transmission and the filter
   2.31. Cooling system – replacement of liquid and washing
   2.32. Replacement of the fuel filter
   2.33. Oil replacement in a manual transmission
   2.34. Oil replacement in a case of the main transfer
   2.35. Check of system of catching паров gasoline (EVAP system)
   2.36. Installation of the light alarm system of need of servicing
   2.37. Replacement of a gear belt
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice

2.16. Check and replacement of candles

GENERAL INFORMATION

New candles should correspond to engine type.

PERFORMANCE ORDER

	1. Check a gap between candle electrodes by means of round щупа. Shchup should move between electrodes under small effort.
	2. If necessary turn in a lateral electrode. To turn in an electrode follows near a bend. Candles turn out on one.
	3. Disconnect from a candle a wire, holding a tip and slightly them turning.
	4. Clear and blow the compressed air of a platform near candles and turn out candles.
5. Check the turned-out candle and estimate an engine condition.
6. Grease a carving of a new candle with structure from прихвата on a copper basis, insert and turn by hand, then tighten with the set moment.
7. Check a condition of wires (see subsection 2.17), dress a wire on a candle, slightly rotating tips and pressing on them. Repeat procedure for other candles.