|
|
1. Before installation of new piston rings sort rings and check a gap in joints. For this purpose push a ring the piston bottom. The ring should be in the lower part of the cylinder, in the situation corresponding to the bottom dead point. |
|
2. If the gap is too small, a thin file carefully file ring end faces, having clamped it in a vice. The increase in a gap in a joint to 1,0 mm is allowed. |
3. Repeat procedure for all rings of one piston. |
|
4. Establish rings on the piston, having begun with the maslosjemny. Establish in a flute a ring divider / dilator. Be convinced available a pin of a flute (if it is provided) and establish the bottom and top disks. |
|
5. At installation of maslosjemny disks to use the adaptation for clothing of rings it is impossible, as their breakage is possible. Insert a disk, press and a finger since one end carry out on a ring, having laid that it in a flute. |
6. Similarly establish rings on other pistons. |