E30 BMW
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engine
+ 3.1.2. Specifications
- 3.2. Dismantle and major maintenance of the engine
3.2.2. Specifications
3.2.3. Major maintenance – the general instructions
3.2.4. Compression check in engine cylinders
3.2.5. Major maintenance – general comments
3.2.6. Engine diagnostics by means of the vacuum gage
3.2.7. Major maintenance – alternatives
3.2.8. Dismantle of the power unit
3.2.9. Removal and engine installation
3.2.10. Order of dismantling of the engine
3.2.11. Dismantling of a head of the block of cylinders
3.2.12. Cleaning and check of a head of cylinders and details of the klapanny mechanism
3.2.13. Repair of valves
3.2.14. Assembly of a head of the block of cylinders
3.2.15. Removal of pistons and rods
3.2.16. Crankshaft dismantle
3.2.17. Intermediate shaft (only M20 engine)
3.2.18. Cleaning of the block of cylinders
3.2.19. Check of a condition of the block of cylinders
3.2.20. Honningovaniye of cylinders
3.2.21. Check of a condition of pistons and rods
3.2.22. Check of a condition of the crankshaft
3.2.23. Check of radical and shatunny bearings
3.2.24. Engine assembly order
3.2.25. Installation of piston rings
3.2.26. Installation of an intermediate shaft
3.2.27. Installation of the crankshaft and check of gaps in radical bearings
3.2.28. Installation of a back epiploon
3.2.29. Installation of rods and pistons, check of gaps in shatunny bearings
3.2.30. Engine start-up after repair and a running in
+ 3.3. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice
3.2.17. Intermediate shaft (only M20 engine)
| GENERAL INFORMATION |
This shaft is intended for a drive of the oil pump.
| PERFORMANCE ORDER | |||||
|