E30 BMW
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
- 11. Running gear
11.1.10. Back springs
11.1.11. Bar of the back stabilizer of cross-section stability
11.1.12. Levers of a back suspension bracket
11.1.13. Bearings of back wheels
11.1.14. Corners of installation of wheels
11.1.2. Specifications
11.1.3. Stabilizer of cross-section stability of a forward suspension bracket
11.1.4. Suspension bracket lever
11.1.5. Rack of a forward suspension bracket
11.1.6. Springs or shock-absorber of a rack of a suspension bracket
11.1.7. Spherical support
11.1.8. Nave of a forward wheel and bearing
11.1.9. Back shock-absorbers
+ 11.2. Steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice
11. Running gear
11.1. Suspension brackets
11.1.1. Introduction
| GENERAL INFORMATION |
Prevention
Forward suspension bracket and steering (view from the bottom party)
|
1. Cross-piece
2. Stabilizer of cross-section stability 3. Rack of the stabilizer of cross-section stability |
4. Suspension bracket lever 5. Rack 6. Tip of steering draft 7. Steering mechanism |
Forward suspension bracket independent such as Mac-Ferson. Racks of a suspension bracket fasten in the top part to the strengthened sites of wheel niches and to suspension bracket levers in the lower part. The stabilizer of cross-section stability fastens to a cross-piece of a suspension bracket and to suspension bracket levers through racks.
General view of a forward suspension bracket
|
1. Top fastening of a rack of a suspension bracket
2. Stabilizer rack cross-section stability 3. Steering draft 4. Suspension bracket lever |
5, 7. Spherical опра suspension bracket lever 6. Steering mechanism 8. Cover 9. Tip of steering draft 10. Suspension bracket rack |
Back suspension bracket
| 1. Shock-absorber 2. Spring 3. Semi-axis |
4. Lever 5. Holder of a reducer of a back axis 6. Stabilizer of cross-section stability |
Back suspension bracket lever, with springs and shock-absorbers. The shock-absorber in the top part fastens to a body, and in the lower part – to the suspension bracket lever. The stabilizer of cross-section stability fastens to suspension bracket levers through racks and collars to a body.
General view of a back suspension bracket
|
1. Shock-absorber
2. Stabilizer of cross-section stability 3. Reducer (main transfer and differential) 4. Internal CV JOINT 5. Back support of a reducer |
6. Covers of CV JOINTS 7. Suspension bracket lever 8. Fastening of the lever of a suspension bracket 9. Cross-piece of a back axis 10. Spring |