E30 series BMW 3

since 1983-1994 of release

Repair and car operation



E30 BMW
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
- 6. Fuel system
   6.2. Specifications
   6.3. Check of system of injection
   6.4. Measuring instrument of a stream of air
   6.5. Throttle branch pipe
   6.6. Regulator of pressure of fuel
   6.7. Nozzle of start-up of the cold engine and thermotimer
   6.8. Check and replacement of nozzles
   6.9. Air proof-reader of idling
   6.10. Order of a decompression of fuel system
   6.11. Check of pressure of fuel
   6.12. The fuel pump, the pump of pumping and the fuel level sensor in a tank
   6.13. Gasoline pipe lines and union
   6.14. Fuel tank
   6.15. Air filter
   6.16. Cable of a drive of a butterfly valve
   6.17. Carburetor
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice



6.16. Cable of a drive of a butterfly valve

Check

PERFORMANCE ORDER
1. Remove an air purifier from a throttle branch pipe (on injector engines) or the air filter (carburetor engines).
2. Be convinced that by pressing a pedal the zaslonka opens completely and is closed at a pedal otpuskaniye.
3. Zaslonka should not touch the case, otherwise replace a throttle branch pipe assembled.

Adjustment

PERFORMANCE ORDER
1. Warm up the engine and stop. Press an accelerator pedal to the full twice and check a free wheeling of a cable on the carburetor (a throttle branch pipe).
2. If the free wheeling of a cable does not correspond to norm, adjust, rotating a nut (And), holding a nut (In).

Replacement

Procedure for injector engines, procedure for carburetor engines differs nothing.

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Release adjusting nuts of a cable and get a cable from a cover arm on a soaking-up collector.
3. Compress a plastic clamp and push it in an arm groove.
4. Turn a butterfly valve and remove a cable through cut in an arm.
5. Remove a cable from an arm, remove a plastic clamp.
6. Disconnect a cable from an accelerator pedal.
7. Stretch a cable through a partition from a motor compartment.
8. Installation is carried out upside-down. Adjust a cable.