E30 series BMW 3

since 1983-1994 of release

Repair and car operation


E30 BMW
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
- 10. Brake system
   10.2. Specifications
   10.3. Anti-blocking system (ABS)
   10.4. Blocks of disk brakes
   10.5. Support of a disk brake
   10.6. Brake disk
   10.7. Blocks of drum-type brakes
   10.8. Main cylinder of brakes
   10.9. Vacuum amplifier of brakes
   10.10. Cable (ы) hand brake
   10.11. Adjustment of the hand brake
   10.12. Mechanism of the hand brake
   10.13. Brake pedal
   10.14. Switch of a signal of braking
   10.15. Hoses and lines of a hydraulic actuator of brakes
   10.16. Air removal from a hydraulic actuator of brakes
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


4d3121b2




10.13. Brake pedal
GENERAL INFORMATION
Prevention

The height of a pedal of a brake should be regulated after removal or replacement of the main cylinder of brakes or the vacuum amplifier. At the same time it is necessary to adjust and the switch of a signal of braking.

Adjustment of height of a pedal (the scheme for and/m with the left wheel, on and/m with the right wheel is carried out similarly)

For adjustment of height of a pedal release a lock-nut (1) and holding a fork, rotate a pusher (2) until the distance And (between bottom edge of an overlay of a pedal and a partition of a motor compartment) will not correspond specified in subsection 10.2.
Prevention

On cars with the right wheel adjustment is carried out on the left side of a shaft after the ware box, however distance on the former is removed is measured from a pedal.