1. Lift the car. On a part of cars it is required to remove an exhaust system and a thermal guard. |
3HP 22 transmission |
|
2. Remove a bracket of a clamp of draft of the selector and disconnect draft of the lever of the selector. For this purpose remove a bracket (1) from a clamp (2), having pulled a bracket for the upper edge, and then having submitted down. |
3. Take away the selector lever on transmission to a limit, then displace in the opposite direction (forward) on 2 clicks. This situation corresponds to the neutral. |
4. In salon the selector establish in situation N. |
5. Ask the assistant to establish the selector lever opposite to the limiter of situation N in a lock. Rotating a clamp on a carving tip of draft, establish it opposite to an opening in the bottom termination of the lever of the selector. Truncate draft, having turned a clamp on 1–2 turns clockwise. |
6. Establish draft on a clamp and check adjustment. For this purpose start the engine, press a pedal of a brake and transfer the transmission selector to all provisions. |
Transmission of 4HP of 22 N / EN |
7. Establish the selector provisions P. |
|
8. Release a nut of fastening of a cable to the lever. On a part of cars the lever can be turned up, instead of down, and carving fastening is replaced with an axis with the shplinty. |
9. Displace the selector lever towards the engine and submit a cable tip in the opposite direction. |
10. Attach a cable and tighten a nut. |
11. Check adjustment. For this purpose start the engine, press a pedal of a brake and transfer the transmission selector to all provisions. |