E30 series BMW 3

since 1983-1994 of release

Repair and car operation

E30 BMW
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
- 8. Transmissions
   - 8.1.2. Specifications
      8.1.3. Check point control lever
      8.1.4. Check point epiploons
      8.1.5. Details of fastening of transmission
      8.1.6. Removal and check point installation
      8.1.7. Manual transmission dismantling
   + 8.2. Automatic transmission
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice

8.1.3. Check point control lever

GENERAL INFORMATION

Mechanism of management of a check point

1. Cover
2. Top section of the lever
3, 6, 7, 35. Spring ring
4. Rubber holder
5, 8. Washer
9. Spring
10. For the stamped case of the mechanism
11. The bearing (for the stamped case) or
persistent ring (for the cast case)
12. Bottom lever
13, 27. Back fastening of the case of the mechanism
check point managements
14. Alyuminevy cast column of switching
transfers
15. Nut
16, 28. Draft
17. Bracket
18, 29. Plug

19, 33. Ring
20, 32. Pin
21, 30. To ползуну a check point
22, 31. Felt epiploon
23, 36. Clamp
24, 40. Bottom bearing
25. Conducting of a signal of a backing
26. Conducting bracket
34. Remote washer
37. Forward fastening of the case of switching of speeds
38. Nut
39. Shtampovy case of switching of speeds
41. Sound-proof laying

Removal and installation

PERFORMANCE ORDER

1. Include back speed, lift a car front.
2. Remove the lever handle.
3. Remove a cover and sound-proof stuffing.
4. Remove an internal cover, previously having disconnected the socket of the switch of a signal of a backing.
	5. Remove a bracket (1) and disconnect the lever (2) from draft of a check point (3).
	6. On cars with the steel stamped case of the mechanism of management of a check point remove a lock ring of the hinge and remove the lever.
	7. On cars with a cast aluminum column of gear shifting turn a lock ring of the bearing of the lever a special key (or having rested 2 screw-drivers) on 1/4 turns and get the lever.
	8. Installation is carried out upside-down. On cars with an aluminum column of gear shifting combine a teeth on a plastic lock ring with grooves in a column and press a ring before click.