E30 series BMW 3

since 1983-1994 of release

Repair and car operation



E30 BMW
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engine
   + 3.1.2. Specifications
   + 3.2. Dismantle and major maintenance of the engine
   - 3.3. Engine electric equipment
      3.3.2. Specifications
      3.3.3. The battery - engine start-up in emergency situations
      3.3.4. Removal and battery installation
      3.3.5. Power cables
      - 3.3.6. Ignition system
         3.3.6.2. Check of system of ignition
         3.3.6.3. Check and installation of the moment of ignition (only for TCI system)
         3.3.6.4. Ignition distributor
         3.3.6.5. Ignition coil
         3.3.6.6. Shaper of impulses and block of electronic ignition
         3.3.6.7. A gap in the shaper sensor (TCI system)
         3.3.6.8. Sensors of system of ignition
      + 3.3.7. System of a charge of the battery
      + 3.3.8. System of start-up of the engine
      3.3.9. Malfunctions of the generator
      3.3.10. Main malfunctions of electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


4d3121b2





3.3.6.4. Ignition distributor

GENERAL INFORMATION

Distributor of system of ignition of TCI

1. Vlagozashchitny cap external

2. Vlagozashchitny cap internal

3. Distributor cover

4. Dustproof screen

6. Spring ring

7. Pin

8. Plate of a rotor of the shaper of impulses

9. Shaper of impulses

10. Socket of the shaper of impulses

11. Distributor case

12. Vacuum regulator

13. Spring ring

Begunok, dustproof cover and sealing ring of the distributor of ignition of DME system

 

Removal and installation of the distributor of ignition – TCI system

PERFORMANCE ORDER
1. Designate and disconnect from the wire distributor. For a detachment of wires remove caps of the distributor of ignition, having hooked in the specified places and having separated parts.
2. Turn out a candle from the 1st cylinder.
3. Expose the piston of the 1st cylinder in VMT of a step of compression (see subsection 3.1.4).
4. Designate and disconnect from the distributor vacuum hoses.

5. Put a label on the distributor case opposite to the index a begunka and designate labels position of the distributor concerning the engine.

6. Unscrew a nut (bolt) of a collar.
7. Remove the distributor.

Prevention

Crankshaft turn after removal of the distributor is not allowed.


8. Installation is carried out upside-down. Previously be convinced that the piston of the 1st cylinder is exposed in VMT of a step of compression. Insert the distributor so that the put labels were combined, at installation the gear wheel of a shaft should turn. Check installation of the moment of ignition.

Removal and installation of the distributor of ignition – Motronic system

PERFORMANCE ORDER
1. Unscrew bolts, remove a cap and a distributor cover.
2. Unscrew 3 screws and remove a begunok from the roller.

3. Installation is carried out upside-down.