E30 series BMW 3

since 1983-1994 of release

Repair and car operation



E30 BMW
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
- 11. Running gear
   11.1.10. Back springs
   11.1.11. Bar of the back stabilizer of cross-section stability
   11.1.12. Levers of a back suspension bracket
   11.1.13. Bearings of back wheels
   11.1.14. Corners of installation of wheels
   11.1.2. Specifications
   11.1.3. Stabilizer of cross-section stability of a forward suspension bracket
   11.1.4. Suspension bracket lever
   11.1.5. Rack of a forward suspension bracket
   11.1.6. Springs or shock-absorber of a rack of a suspension bracket
   11.1.7. Spherical support
   11.1.8. Nave of a forward wheel and bearing
   11.1.9. Back shock-absorbers
   - 11.2. Steering
      11.2.2. Tips of helmsmen ятг
      11.2.3. Covers of the steering mechanism
      11.2.4. Steering mechanism
      11.2.5. Pump of the hydraulic booster
      11.2.6. Air removal from the power steering
      11.2.7. Steering wheel
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


4d3121b2





11.2.2. Tips of steering drafts

Removal and installation

PERFORMANCE ORDER
1. Lift a front of the car and remove wheels.
2. Release a nut and выпрессуйте a finger of a tip of draft a stripper (or beat out in easy blows of a hammer). Unscrew a nut and disconnect a draft tip from an eye on the rack case.
3. Release a bolt of a collar of a tip of steering draft. Designate the provision of a tip on draft (or measure length of a tip concerning a draft end face) that at assembly to wrap a tip in former situation. Turn out a tip from steering draft.
4. Installation is carried out upside-down. Wrap a tip before coincidence of labels, or expose the measured length of a tip.
5. Upon termination of check corners of installation of wheels in car-care center.