E30 series BMW 3

since 1983-1994 of release

Repair and car operation

E30 BMW
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
- 11. Running gear
   11.1.10. Back springs
   11.1.11. Bar of the back stabilizer of cross-section stability
   11.1.12. Levers of a back suspension bracket
   11.1.13. Bearings of back wheels
   11.1.14. Corners of installation of wheels
   11.1.2. Specifications
   11.1.3. Stabilizer of cross-section stability of a forward suspension bracket
   11.1.4. Suspension bracket lever
   11.1.5. Rack of a forward suspension bracket
   11.1.6. Springs or shock-absorber of a rack of a suspension bracket
   11.1.7. Spherical support
   11.1.8. Nave of a forward wheel and bearing
   11.1.9. Back shock-absorbers
   + 11.2. Steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice

11.1.5. Rack of a forward suspension bracket

GENERAL INFORMATION

Prevention

Racks of a suspension bracket are recommended to be changed at the same time.

Cнятие and installation

PERFORMANCE ORDER

1. Release bolts of forward wheels.
2. Lift a car front.
3. Remove a wheel.
4. Disconnect from the rack case all hoses and wires.
5. Disconnect ABS system sockets (if are provided).
6. At removal of the left rack disconnect the socket of the sensor of wear of blocks.
	7. Unscrew a bolt of fastening of the sensor of ABS system (if it is provided), remove a brake disk, previously having removed a support (see subsection 10.4) (bolts of fastening of a support of a brake are specified by shooters).
	8. Remove a brake board.
	9. Disconnect the stabilizer of cross-section stability from a stabilizer rack, having unscrewed a fastening nut (it is specified by an arrow).
	10. Disconnect a spherical support of the lever of a suspension bracket from a rotary fist (shooters specified samopodzhimny nuts of fastening of a spherical support and a tip of steering draft).
11. Disconnect steering draft.
12. Take away the lower part of the case of a rack from the suspension bracket lever.
	13. Unscrew 3 nuts of the top fastening of a rack from a motor compartment. Previously establish under a rack a prop.
14. Remove a rack. A replacement procedure of the shock-absorber of a rack see in subsection 11.1.6.
15. Installation is carried out upside-down. Replace all samopodzhimny nuts on fingers of spherical support, a tip of steering draft and on the top fastening of a rack of a suspension bracket. Tighten all connections with the moments specified in subsection 11.1.2.
16. After assembly check and adjust corners of installation of wheels in car-care center.