E30 series BMW 3

since 1983-1994 of release

Repair and car operation



E30 BMW
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
- 11. Running gear
   11.1.10. Back springs
   11.1.11. Bar of the back stabilizer of cross-section stability
   11.1.12. Levers of a back suspension bracket
   11.1.13. Bearings of back wheels
   11.1.14. Corners of installation of wheels
   11.1.2. Specifications
   11.1.3. Stabilizer of cross-section stability of a forward suspension bracket
   11.1.4. Suspension bracket lever
   11.1.5. Rack of a forward suspension bracket
   11.1.6. Springs or shock-absorber of a rack of a suspension bracket
   11.1.7. Spherical support
   11.1.8. Nave of a forward wheel and bearing
   11.1.9. Back shock-absorbers
   + 11.2. Steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


4d3121b2





11.1.14. Corners of installation of wheels

GENERAL INFORMATION

The convergence of forward wheels is regulated by change of length of steering draft at the released collar.

For adjustment of disorder of wheels at car repair shop the top support of a rack of a suspension bracket which fastens these nuts is rearranged. The top support provides necessary correction of a corner of an axis of a rack.

The convergence of back wheels is regulated by replacement of plugs of levers of a suspension bracket by the dissymetric. Marking on the plug indicates size of an increment of a corner of a convergence.

Corners of installation of forward wheels

1. Vertical

2. Disorder of wheels (front view)

3. Line parallel to an axis of symmetry of the car

4. Axis of turn of a wheel

5. Longitudinal tilt angle of an axis of turn

6. Convergence of wheels

7. To a forward part of the car


disorder With = A-in;

convergence = E-F (it is expressed in mm);

G–a corner of a convergence of wheels (it is expressed in degrees)

Wheels and tires

On considered cars radial tires are established. Tires should change in a set on an axis. At installation on an axis of tires of different manufacturers track, that protector drawing, the design and the size of tires were identical.

Change disks at strong damages (a bend, dents).

The new wheel should be otbalansirovano before installation on the car.

Corners of installation of wheels

The corner of disorder of wheels, tilt angle of an axis of turn and convergence of wheels are subject to check. Definition of corners of installation of wheels is shown on the scheme.

Corners of installation of wheels are checked and regulated in car-care center. On forward wheels are regulated a convergence of wheels (on a part of cars) and disorder of wheels. The tilt angle of an axis of turn is not regulated.

Disorder of wheels is regulated only at replacement of knot of the top fastening of a rack in knot in which the special clown, providing necessary correction of disorder of wheels is provided. The convergence of back wheels is regulated by replacement of external plugs of levers of a back suspension bracket by similar knots with asymmetry of plugs.