E30 series BMW 3

since 1983-1994 of release

Repair and car operation

E30 BMW
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
- 8. Transmissions
   + 8.1.2. Specifications
   - 8.2. Automatic transmission
      8.2.2. Specifications
      8.2.3. Diagnostics of automatic transmission
      8.2.4. Draft of the selector of transmission
      8.2.5. Kick-down-mode cable
      8.2.6. The blocking switch / switch of a signal of a backing
      8.2.7. Removal and transmission installation
      8.2.8. Epiploons of automatic transmission
      8.2.9. "Machine gun"
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice

8.2.8. Epiploons of automatic transmission

Replacement

PERFORMANCE ORDER

Hydrotransformer epiploon
1. Remove transmission and the hydrotransformer (see subsection 8.2.7).
	2. Check a condition of the plug of the hydrotransformer. If the plug is strongly worn-out, replace the hydrotransformer, small damages of the plug try to remove them with a small skin.
	3. Carefully get an epiploon the adaptation.
4. Grease edges of a new epiploon with liquid and press an opravka resting against an external part of an epiploon.
5. Establish the hydrotransformer. Track, that it completely came into gearing with the pump (turn the hydrotransformer, pushing). Further assembly is carried out upside-down.
Epiploon of the lever of the selector of transmission
6. Lift the car.
7. Remove the lever from a transmission shaft, without disconnecting draft.
8. Carefully get an epiploon the adaptation or a small screw-driver.
9. Grease edges of a new epiploon with liquid and press an opravka resting against an external part of an epiploon.
Epiploon of a shaft of transmission
10. Lift the car.
11. Remove exhaust pipes and the driveshaft (see subsection 9.10).
12. Unbend a kontrovochny teeth of a lock washer and unscrew a nut. Remove a flange.
13. Grease edges of a new epiploon with liquid and press an opravka resting against an external part of an epiploon. Dress a flange and tighten a nut, having greased with hermetic its internal surface. Further assembly is carried out upside-down.

General instructions

After replacement of any of epiploons check level of transmission liquid, if necessary restore.