Epiploon of a secondary shaft |
1. Lift a forward part of the car. |
2. On a part of cars remove an exhaust system. |
3. Disconnect from a check point the driveshaft and fix. The shaft can be not disconnected from the back bridge. |
4. Bend ears of a lock washer and remove a washer. Holding a flange, unscrew a nut a face key on 30 with thin walls. Remove a flange a stripper. |
|
5. Carefully выпрессуйте c epiploon help of the special adaptation. |
6. Installation is carried out upside-down. An epiploon press an opravka. A nut tighten on fixing structure with the set moment. |
Epiploon of a rod of gear shifting |
7. Execute the actions specified in points 1, 2, 3. Disconnect draft from a rod for what on early models remove a lock ring and beat out a pin. On late models include the 3rd transfer, take away the podpruzhinenny plug and beat out a pin. |
8. Carefully get an epiploon a special stripper. |
9. Installation is carried out upside-down. An epiploon press an opravka. |
Epiploon of primary shaft of a check point |
10. Remove a check point (see subsection 8.1.6). |
11. Remove vyzhimny the bearing (see subsection 9.9). |
|
12. Unscrew bolts and remove a sleeve of the bearing and laying. Pay attention to an arrangement of bolts. |
13. A screw-driver or a stripper get an epiploon and an opravka press new, having greased working edges. |
14. At assembly with a check point of the ZF type replace laying of a sleeve of the vyzhimny bearing, new laying grease with hermetic. On a Getrag type check point the sleeve of the vyzhimny bearing is established on ring laying or on hermetic. |