E30 series BMW 3

since 1983-1994 of release

Repair and car operation



E30 BMW
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
- 5. Heating and ventilation
   + 5.1.2. Heater and conditioner fan
   - 5.2. Central air
      5.2.2. Care of central air
      5.2.3. Compressor
      5.2.4. Condenser
      5.2.5. Moisture separator
      5.2.6. Conditioner evaporator
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


4d3121b2





5.2.5. Moisture separator

GENERAL INFORMATION

Moisture separator

1. Relay of a high pressure
2. Conditioner highways
3. Relay of low pressure
4. Socket

On a part of cars the moisture separator is mounted behind a back headlight.

Removal and installation

PERFORMANCE ORDER
1. Depressurize the conditioner and remove a coolant in car-care center.
2. Disconnect the battery from weight.
3. Remove a tank of a washer of a windscreen.
4. Disconnect from sensors of a moisture separator of a wire (on a part of cars there can be one sensor of pressure).
5. Unscrew screws and remove a moisture separator.
6. Installation is carried out upside-down. If the new moisture separator is established, be guided by the instruction attached to this unit, rearrange on it pressure sensors. Replace a sealing ring. Fill system with a coolant in car-care center.