E30 series BMW 3

since 1983-1994 of release

Repair and car operation



E30 BMW
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
- 5. Heating and ventilation
   - 5.1.2. Heater and conditioner fan
      5.1.3. The control panel the block a heater - the conditioner
      5.1.4. Heater radiator
   + 5.2. Central air
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


4d3121b2





5.1.2. Heater and conditioner fan

Removal, check and installation

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. The fan of a heater is mounted under a dividing partition of a motor compartment and salon and closed by the panel. Unscrew forward and top screws of fastening of the panel of the fan.
3. Get conducting, having disconnected (or having cut off) a binding, and take aside.
4. Remove the panel.
5. Unbutton locks of a tape of fastening of a casing of the fan.
6. Unbutton locks of a tape of fastening of the fan.

7. Disconnect wires and remove the fan.
8. Connect the fan to the battery through a fusible crossing point. If operation of the fan is accompanied by the increased noise, or speed of rotation low, replace the fan electric motor. At removal of a krylchatka designate her situation on an electric motor shaft not to break balancing.
9. Assembly is carried out upside-down.