E30 series BMW 3

since 1983-1994 of release

Repair and car operation

E30 BMW
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
- 13. Electric equipment
   13.1.2. Search of malfunctions
   13.1.3. Safety locks
   13.1.4. Relay
   13.1.5. Breaker of indexes of turn / alarm system
   13.1.6. Switches on a steering column
   13.1.7. Ignition lock
   13.1.8. Receiver
   13.1.9. Aerial
   13.1.10. Guard of devices
   13.1.11. SI payment (maintenance index)
   13.1.12. Headlights – replacement of lamps
   13.1.13. Adjustment of headlights
   13.1.14. Headlight case
   13.1.15. Replacement of lamps
   13.1.16. Screen wiper electric motor
   13.1.17. Heater of back glass
   13.1.18. Safety cushions
   13.1.19. System cruise control
   13.1.20. The central locking system
   13.1.21. Electric stelokpodjemnik
   + 13.2. Electroschemes
+ 14. Good advice

13.1.16. Screen wiper electric motor

PERFORMANCE ORDER

1. Disconnect the battery from weight.
Electric motor of a forward screen wiper
	2. Hook and uncover lever nuts.
	3. Unscrew a nut and get a magnet a washer.
4. Hook and get latches and remove a lattice.
5. Unscrew screws and nuts and uncover a screen wiper drive on a partition of a motor compartment.
6. Disconnect the socket and draft of a drive.
7. Designate mutual position of draft and the roller, having carefully hooked a screw-driver, remove draft from the electric motor roller.
8. Unscrew three bolts of fastening, raise the electric motor of a screen wiper and remove.
9. Installation is carried out upside-down. If necessary expose the electric motor roller in the provision of a parking of brushes. For this purpose attach the socket, include and at once switch off a screen wiper.
Electric motor of a back screen wiper
	10. Uncover, unscrew a nut and remove the lever of a shchetkoderzhatel from a shaft.
11. Remove the decorative panel and disconnect the socket of conducting and a washer hose.
	12. Unscrew nuts and remove the electric motor of a cleaner of back glass.
13. Installation is carried out upside-down. If necessary expose the electric motor roller in the provision of a parking of brushes. For this purpose attach the socket, include and at once switch off a screen wiper.